08/08/26 - Reformer 112 (Neo Creamback) - USA

Hey Alex, quick question about the Reformer 112 low cut:

I just got this cab and I always confirm a proper load before plugging in my tube amps to any cab by measuring the resistance across the positive/negative terminals of a plugged in speaker cable. With the low cut in the off position, I am measuring approximately 8 ohms from a Neo Creamback 8 ohm driver, but when I switch the low cut on I am unable to measure any resistance on my multimeter.

I just wanted to ask if this is normal behavior, and if there is any way to confirm that it is safe to operate with the low cut on with my tube amps?

Thanks, and the cab sounds phenomenal!

Mitch

---------------------------------------------------------------------------------------

Hi Mitch,

Yes, that's absolutely normal and it's fine. Glad it's sounding good!

Best regards,

Alex